This elbow can be used to manually adjust the waste gate along with the Quadzilla Boost Fooler for 98.5-04 5.9L Dodge.
This is a replacement part from Edge but has been recomended by Quadzilla to increase boost. Because of this there are no instructions and there is no clamp to attatch the hose. A small 1/2 inch hose clamp will need to be purchased seperately from your local auto shop.
The instalation instructions have been provided below.
Please note that no instructions are included with this elbow, please print the instructions below.
Boost Elbow Installation
The installation of the brass elbow permits turbo boost pressures of greater than 20 psi without the waste gate opening.
1. Using the 5/16” socket, loosen the two clamps securing the air induction hose to the air filter housing and the turbo inlet. Remove the hose and set it aside.
2. Using the pliers, remove the crimp style clamp from the hose on the brass fitting located on the now exposed lower front side of the
turbocharger. Remove the hose from the brass fitting and dispose of the crimp style clamp.
3. Using the 7/16” wrench, unscrew the stock brass fitting out of the turbocharger housing. Using the 7/16” wrench, install the supplied
brass fitting, tighten-be careful not to over-tighten. Slip the hose clamp (this clamp is not included and must be purchased seperately) onto the stock hose, install the stock hose onto the supplied brass fitting and tighten the hose clamp with the 1⁄4” socket. Reinstall the stock air hose onto the air filter housing and turbocharger inlet. Using the 5/16” socket, tighten both clamps securely.
4. Using the 7/16 deep socket tighten all of the intercooler hose clamps on the air intake.
